Signet PDA11/SD 1000M² pro ringleiding versterker met XLR mic/line in

Beschrijving

Alle ringleiding materiaal wordt speciaal besteld en u heeft geen teruggaaf recht op deze artikelen.

• Supply Voltage: 230V ∿ 50Hz (Free-standing model is supplied with IEC 320 fused mains lead; Wall-mount
  model is permanently connected to mains)
  Power Consumption: 100W / 200W / 400W (model dependent)
  INPUTS
  Line In: Input impedance: 1k + or – input to ground.
  Sensitivity: -20dBU typical.
  Microphone:
  Input impedance: 1k + or – input to ground.
  Sensitivity: -42dBU typical.
  Phantom power for electret microphones: 12V selectable (on/off).
  Outreach:
  Input impedance: >10k.
  Sensitivity: 0dBU typical.
  Outreach power: 24V d.c. nom. is available via the amplifier’s outreach connector (100mA max.)
  Optical (if fitted): TOSLink digital receiver. Up to 24 bit, 96kHz sampling.
  OUTPUTS
  Loop 1 &
  Loop 2 (if fitted):
  Type: True current mode. Loop output voltage: 14V.
  Single Loop drive current @ 1 ohm: 4.75A (PDA5/SD, PDA5/SW); 7.5A (PDA7/SD, PDA7/SW); 11A
  (PDA11/SD, PDA11/SW).
  Dual Loop drive current @ 1 ohm: 2 x 3.25A (PDA5/DD, PDA5/DW); 2 x 5A (PDA7/DD,
  PDA7/DW); 2 x 7.5A (PDA11/DD, PDA11/DW).
  Line Out: 775mV output
  Fault Relay: Single pole double throw (SPDT): NC, Common, NO.
  Phase Shift (if fitted): 2 x 900 phase shifted. Selectable (on/off).
  Metal Compensation: Up to 10dB / octave design counteracts frequency dependent absorption by metal in the
  installation over a bandwidth of approximately 5kHz.
  COVERAGE
  Maximum Coverage Area:
  200m2, i.e. rooms up to approx. 14m x 14m (PDA5/DD, PDA5/DW).
  500m2,
  , i.e. rooms up to approx. 22m x 22m (PDA7/DD, PDA7/DW).
  1000m2, i.e. rooms up to approx. 31m x 31m (PDA11/DD, PDA11/DW).
  Loop impedance: 0.5 to 2 ohm.
  PERFORMANCE
  Frequency Response (-3dB): 100Hz to 5kHz; Distortion: Less than 1 % typical; Signal to Noise Ratio: Better than –65dB any
  input; AGC Range (3dB change in output voltage current): 10dB. AGC ratio: 20:1.
  SUPPLEMENTARY
  Sensitivity Level Controls
  (lockable):
  Line Input, Microphone, 12V Phantom, Outreach, Metal Comp, Loop Drive 1, Loop Drive 2 (if
  fitted), Phase Shift (if fitted).
  Display & Controls: LED display with 4 membrane control buttons.
  Connectors:
  • Microphone (3-pin XLR Type – Free-standing model; 3-way pluggable connector – Wall-mount model).
  • Line In (3-pin XLR Type – Free-standing model; 3-way connector – Wall-mount model).
  • Loop (2 or 4 way binding post – Free-standing model; 2 or 4-way connector – Wall-mount model).
  • Outreach (4-way pluggable connector).
  • Line Out (3-way pluggable connector).
  • Fault Relay (3-way pluggable connector).
  • Optical (if fitted).
  • 230Va.c. connector (Mains lead supplied for Free-standing model; Fixed mains connection
  for Wall-mount model).
  Overall Dims. (H x W x D): Free-standing models: 67mm (H) x 218mm (W) x 280mm (D)
  Wall-mount models: 298mm (H) x 308mm (W) x 74mm (D)
  Weight: Free-standing models: 2.38kg; Wall-mount models: 3.35kg
  Panel Construction: Mild steel zintec, 1mm thick, black powder coated IP Rating (EN 60529): IP40
  Operating Temperature: 00
  C to 400
  C Maximum Humidity: 95% non-condensing